Blocks - how to use and tie a on rope

Manual for blocks to download in PDF HERE

Some information about CNC wooden blocks: blocks have on one side a small stalks after the final mill. These stalks are not possible to remove when blocks are finished during final sanded. The hand grinding of the stem of thousands of blocks is not in my power. I hope you will not mind. The stalk is easy to grind off by a few strokes before gluing a ropes.
The wooden blocks had usually darker color. Therefore it is possible to stain them - the best way to do that is in alcoholic stain on wood. Put the wooden blocks into the stain and leave it in for 10 to 20 minutes. Then let it dry out on a smooth non-absorbent surface.

The rope for this use must be minimally as strong as the rope lead through the block. The rope is pasted by some adhesive material – „flexible superglue“. There is better way to use "flexible superglue „adhesive material, because the joint is flexible after getting dry, too. The block is convenient to be hold by fixed pincette. 
Then paste rope from the side, after getting dry from the other side. Coat with glue either sides of block or the rope during this procedure. It is necessary to take care of that rope must not stiffen outside the block, because of possibility to tie knots on it and even the block hangs on the boat naturally. Take care of pasting rope around midpoint of block. The rope pasting on a slant looks unsightly especially on big blocks. It is true, that you can´t hardly avoid unwanted visible staining surfaces by glue. Remove it by coating this place with some matt lacquer. I usually use fork made of needle for coating surfaces by glue. It is recommended to wet the rope slightly before using adhesive material because of better getting dry after the procedure.

Next procedure depends on size and width of the block. At blocks size 2 – 4 mm with 1 or 2 holes do knots just past the block.

If the block is wide enough, ropes surrounding the block are next to each other.  In distance about 2 – 4 mm according to the width of block tie both ropes  by thin thread together, paste the knot immediately and cut away one end. Wind the other end around the ropes in direction closely at the block for better fixation the joint.​

Search

Send newsletter

Insert here your email...

Logout newsletter

Bestsellers

Flag Toplist

Flag Counter

Valid XHTML 1.1

 

Ship kits

Accessories of Ship models

Standard modelers e-shop

Workfow

Photogalery

Plans of ships

 

Terms and Conditions

Terms of delivery

Payment Terms

Registration

How to order

Radimír Beseda - HiSModel.com
B. Nikodéma 4476/15
708 00 Ostrava
Czech Republic

Identif. number: 04581954
Tax indentity: CZ6207291640

mobil: +420 736 643 287

email: message@HiSModel.com

web: www.HiSModel.com

Write to us here

 

Webdesign – AiVision, s.r.o. | Eshop - AiShop

Banner overload

Banner overload text

Responzivní design menu

Kategorie
Menu
Vyhledávání
Přihlášení
Nahoru